06-06-2016 08:53 AM
I'm trying to find resources on 802.1q and how to configure my VDX 6740. I find little bits and pieces but they don't make sense when the setting for Cisco is extremely simple "switchport trunk encapsulation dot1q"
06-06-2016 09:47 AM
Setting up the VDX6740 should also be quite simple and follows the Cisco structure (from what I recall of Cisco)
for example to add vlan 10 to an interface
int vlan 10
int te 1/1/1
switchport mode trunk
switchport trunk allow vlan add 10
That's about it. The VDX6740 only supports 802.1Q as a trunk encapsulation so you don't need to specify the trunking protocol.
This is covered in more detail in the L2 switching guide