Application Delivery (ADX)

Reply
Occasional Contributor
mshah1
Posts: 19
Registered: ‎03-23-2011

network/switch ports utilization balancing

Hi,

i have deployed/installed Brocade ADX by using one cable/one port (Router on stick a term used by CISCO). all the traffic passes using Ethernet port 1 for Real servers /remote real servers and clients; the peak utilization is less than 200 Mbps.

Some real servers are in different vlan.

I want to distribute the bandwidth utilization between multiple ports as i have ADX-1016-4.

So is there a document/white paper for this.

thanks.

Contributor
msahni
Posts: 28
Registered: ‎08-18-2011

Re: network/switch ports utilization balancing

You can refer to "ServerIron ADX Switch and Router Guide" for details about available options.

I am not much sure about your topology but you can go through chapter 3 "Configuring Trunk Groups and Dynamic Link Aggregation".

Regards,

Mohit

Join the Community

Get quick and easy access to valuable resource designed to help you manage your Brocade Network.